The first half of every year is the peak sales season for the kiln brick industry. Brick balers will inevitably experience minor malfunctions under long-term and high-frequency working conditions. For example, the baler motor may become stuck, or the pulling force may vary from time to time, etc. Today, let me share with you the reasons why the pneumatic baler cannot be tightened and how to deal with it.

Pneumatic baler

       Pneumatic balers frequently fail to tighten. We must first consider the problem of the tightening wheel of the machine. The tightening wheel is particularly critical in the entire packaging process. It is responsible for pulling the strapping for tightening and welding. If the tightening wheel is worn, it will not be able to pull the strapping, causing the strapping to fail to tighten. In this case, you only need to promptly replace the corresponding tightening wheel accessories according to the model of the pneumatic baler. At the same time, the wear of the tightening wheel should be carefully observed during daily work.
        When the tightening wheel wear is ruled out, we need to check whether the machine's motor and lower gear plate are normal. If the lower gear is broken, the treatment method is the same as the tightening wheel, and it can be replaced in time. If the motor is broken, the entire machine will not be able to operate normally, and it needs to be sent back to the manufacturer or a professional repair shop for repair or replacement.

Pneumatic brick factory baler

        If the machine's motor and accessories are running normally, we can pay attention to the air source of the pneumatic baler, because the pneumatic baler mainly relies on the air source to work. If the air source is unstable, it will not be able to give the baler enough driving force, and it will naturally become unable to tighten. In this case, just check whether the air pump and air connection port are complete.
        The above is a brief introduction to the frequent failure to tighten the pneumatic baler. For more detailed operations, you can directly call the consultation hotline: 13647419800 for detailed information. When the pneumatic baler fails to work, you can refer to the product manual or ask professional maintenance personnel to handle it. Never disassemble the baler without knowing the accessories of the baler to avoid irreparable losses.